This guide is intended to provide you details on how well this laptop works with Linux and which drivers you need to configure. For details on how to actually install and configure the required drivers have a look at our guides section for distribution specific instructions.

Page Contents Introduction Editing This Page Specifications Linux Compatibility Notes Related Resources Summary

If you are looking to purchase this laptop you can visit HP's Presario notebook page.

Introduction

This is a guide to running Linux with the HP-Compaq Presario B2800 laptop.

Editing This Page

View our Editing Guidelines

Specifications

Processor	Intel Pentium-M 740 1.73GHz
Screen	14.1" XGA
RAM	512MB
HDD	60GB
Optical Drive	DVD+-RW
Graphics	ATI Mobility Radeon x600
Network	10/100 Ethernet, Intel 2200 802.11g Wireless
Other	3 x USB2.0, 1 x Firewire

Linux Compatibility

Device	Compatibility	Comments
Processor	Yes
Screen	Yes
Optical Drive	Yes
Graphics	Yes
Sound	Yes	Use the snd-hda-intel driver
Ethernet	Yes
Wireless	Yes	Use the ipw2200 driver
56K Modem	Not Tested
USB	Yes
Firewire	Not Tested
SD Card Reader	Not Tested
PCMCIA	Not Tested

Notes

For the graphics chip you can use either the open source radeon driver or ATI's proprietary fglrx driver. For installation instructions, you can view our Configuring an ATI graphics chip guide. For 3D support, you will need the proprietary driver. Some older versions of X may not have support for the ATI Mobility Radeon x600, in this case you will need to use the proprietary driver.

Related Resources

Preparing your laptop for Linux
Configuring an ATI graphics chip
Increasing battery life

Summary

There were no problems in getting this laptop working when used with an up to date Linux distribution. It is recommended to use a Linux distribution with kernel version 2.6.16 or greater, such as Fedora Core 5 or Ubuntu 6.06.


Have you installed Linux on this laptop? If so how about leaving a comment about your success in the comments section below.